X6512 Flash File -

The flash file is the bridge between the development environment (your compiled firmware) and the physical device. An incorrect file format, mis‑aligned data, or corrupted checksum will either fail to program or, worse, brick the hardware. 2. Typical Use Cases | Scenario | How the X6512 flash file is used | |----------|-----------------------------------| | Factory programming | During PCB assembly, a production line programmer writes the master firmware image to every board. | | In‑field OTA/USB update | The device’s bootloader reads a flash file from external storage (SD‑card, USB) and flashes it to internal memory. | | Debugging / Development | Engineers use a JTAG/SWD or serial programmer to push a new binary for testing. | | Configuration storage | Some systems embed a small configuration blob (e.g., calibration tables) inside the flash image. | 3. File Formats & Structure 3.1 Raw Binary ( *.bin ) | Byte offset | Description | |------------|-------------| | 0x0000 – 0xFFFF | Bootloader (if present). Fixed size (e.g., 64 KB) and must be placed at the beginning of the flash. | | 0x10000 – … | Application firmware (code + data). Usually aligned on a 4‑KB sector boundary. | | … | Optional data sections (e.g., assets, configuration tables). May be placed at the end of the image. |

# Program a .x65 container xflashprog -p /dev/ttyUSB0 write -f firmware.x65 -a 0x0 x6512 flash file

The programmer will abort with an “out‑of‑range” error. Trim the image, split it into multiple partitions (if your bootloader supports it), or upgrade to a larger capacity part. The flash file is the bridge between the

Use the partial‑program feature of the bootloader: send a small *.bin that contains the new config and the address offset. The bootloader will erase only the sector containing the config and rewrite it. Typical Use Cases | Scenario | How the

# Optionally convert to .x65 x65wrap -i backup.bin -o backup.x65 | Method | Typical Tools | Steps | |--------|---------------|-------| | Standalone ISP programmer | XFlashProg , FlashCatUSB , Segger J-Link (with flash driver) | 1. Connect programmer to the SPI pins (CS, SCK, MOSI, MISO). 2. Load .bin / .x65 in the GUI or CLI. 3. Verify/Erase/Program. | | Bootloader‑based update | XBootloader (UART, USB, CAN), custom bootloader firmware | 1. Put device in bootloader mode (e.g., pull BOOT0 low, send “0x55” over UART). 2. Transfer the flash file using XModem/YMODEM or a custom protocol. 3. Bootloader validates CRC and flashes. | | In‑system (via MCU) | HAL HAL_FLASH_Program() , X6512_Prog() API | 1. Load the binary into RAM (e.g., via UART). 2. Call the flash‑write routine sector‑by‑sector. 3. Optionally verify with HAL_FLASH_Program() return status. | Example: Flashing via XFlashProg (CLI) # Erase the entire chip first xflashprog -p /dev/ttyUSB0 erase

# 1️⃣ Compile - name: Build firmware run: | make clean all arm-none-eabi-objcopy -O binary build/app.elf build/app.bin