[ v_i = \sqrt{\frac{T}{2\rho A}} ]
A key limit in forward flight is retreating blade stall . At high forward speeds, the retreating blade’s angle of attack must become very large to generate lift equal to the advancing side, leading to stall, vibration, and loss of roll control. The maximum speed of conventional helicopters is often determined by this phenomenon, not engine power. One of the helicopter’s most remarkable safety features is autorotation—the ability to land safely after engine failure. In powered flight, air flows downward through the rotor (induced flow). In autorotation, the pilot lowers collective pitch, and air flows upward through the rotor from below. The rotor acts like a windmill: the relative airflow drives the blades, maintaining rotor RPM. The outer part of the blade operates in a “driving region” (aerodynamic forces accelerating the blade), while the inner part is a “driven region” (consuming energy). The transition between these regions occurs where the total aerodynamic force vector tilts slightly forward of the axis of rotation. [ v_i = \sqrt{\frac{T}{2\rho A}} ] A key
Leishman emphasizes that BET must be combined with inflow models (e.g., Glauert’s theory or free-vortex methods) because the induced velocity distribution over the disk is non-uniform—higher at the retreating blade side, lower at the advancing side, especially in forward flight. In forward flight, the advancing blade experiences higher relative airspeed than the retreating blade. Without compensation, this would roll the helicopter violently. The solution is blade flapping : blades are hinged at the root (or made of flexible materials) to allow upward or downward motion. As an advancing blade produces more lift, it flaps up, reducing its angle of attack (due to the resulting downward relative velocity). The retreating blade flaps down, increasing its angle of attack. This equalizes lift across the disk. One of the helicopter’s most remarkable safety features
Leishman provides a detailed momentum and blade element analysis of autorotation, explaining that the autorotative descent rate is typically 1500–2000 ft/min—survivable with proper flare at landing. He also discusses the height-velocity diagram (avoid curve), which shows combinations of altitude and airspeed where safe autorotation is impossible. Helicopter rotors operate in a highly unsteady environment. Two of the most challenging phenomena are dynamic stall and BVI. The rotor acts like a windmill: the relative