Not always, but in a pinch, stranded 18-gauge wire soaked in flux outperforms no wick at all. Keep a 6" piece pre-fluxed in a tiny ziplock bag in your go-kit. 3. The "Eyeglass" SMA Wrench (Free & Perfect) The problem: SMA connectors need to be finger tight plus 1/8 turn . Overtighten, and you’ll snap the center pin or ruin the female receptacle (especially on cheap HTs or SDR dongles).
Use vulcanizing silicone tape (often sold as "rescue tape" or "self-fusing silicone tape"). It’s about $8–10 per roll. Stretch it 100% as you wrap—it fuses to itself into a solid rubber sleeve. New- Hints and Kinks for the Radio Amateur
Zero adhesive residue. Removes cleanly. UV and weatherproof for years. Temperature range: -60°F to +500°F. One roll seals dozens of connectors. Use it over electrical tape, not under. 5. The Ruler-on-the-Mast Trick (Antenna Matching) The problem: You’re tuning a 1/4-wave ground plane or a J-pole. You slide the radiator up and down, mark it with a Sharpie, lower the mast, adjust, raise again… repeat. Not always, but in a pinch, stranded 18-gauge
Remove the knob. Drip 2–3 drops of isopropyl alcohol (91% or higher) into the shaft opening. Rotate the pot back and forth fully 20–30 times. Let it dry 5 minutes. Then add one tiny drop of lightweight machine oil (sewing machine oil or even 3-in-1) to the same spot. Rotate again 10 times. The "Eyeglass" SMA Wrench (Free & Perfect) The
WD-40 leaves a residue that attracts dust. This alcohol+oil method flushes oxidation then leaves a clean, thin lubricant film. 7. The "No-Drill" Ground Bus for a Metal Desk The problem: Your station ground needs a common bus bar, but you don’t want to drill into your nice metal desk or filing cabinet.
Now get on the air—and keep the hints coming.