Htri Heat Exchanger Design May 2026

She switched to instead of single. HTRI’s geometry builder rendered the new arrangement: two baffle windows per baffle, promoting more longitudinal flow. The pressure drop plummeted to 55 kPa, and U rose to 275 W/m²·K. Nearly there.

She clicked to the (shell-and-tube) module. The color-coded flow map showed dead zones near the shell’s center. The baffle spacing was too wide—fluid was meandering, not turbulent. She reduced baffle spacing from 500 mm to 300 mm. Re-ran. htri heat exchanger design

Better. U climbed to 250. But pressure drop on the shell side spiked—from 40 kPa to 95 kPa, exceeding the 70 kPa limit. Trade-off city. She switched to instead of single

But a new warning blinked red: Vibration potential. Bundle natural frequency close to vortex shedding frequency. Nearly there

Results: 35% baffle cut dropped pressure drop to 65 kPa (good) but U fell to 235 (bad). 20% baffle cut? Pressure drop: 110 kPa—unsafe for the diesel pump. She needed a different geometry entirely.