// Disable low-power modes during debug __HAL_DBGMCU_DISABLE_SLEEP(); __HAL_DBGMCU_DISABLE_STOP(); __HAL_DBGMCU_DISABLE_STANDBY(); Then, erase the faulty firmware that put the chip to sleep.
You can read the device ID, you can see the target voltage, but the moment you try to erase or flash firmware, the programmer halts with this message. This post explains why this happens and provides a step-by-step guide to resolve it. Flash Loader Ip Not Loaded On Device 1
Few things are more frustrating in embedded development than a successful connection to your microcontroller, only to be met with the cryptic error: Few things are more frustrating in embedded development
ST-Link_CLI -c SWD UR -ME (Where -c SWD UR = Connect SWD Under Reset, -ME = Mass Erase) Then try programming again. Flash Loader IP
Fixing the "Flash Loader IP Not Loaded on Device 1" Error in STM32 Programming
Have another workaround? Share it in the comments below! Keywords: STM32, Flash Loader IP, ST-Link, CubeProgrammer, SWD error, embedded debugging, firmware recovery
The "Flash Loader IP Not Loaded on Device 1" error sounds complex, but it usually means the CPU is asleep or stuck. By using or switching to the System Memory Bootloader , you can almost always recover the device. Never throw away an STM32 that shows this error – it is almost certainly recoverable.