10 Industrial Electrical Training Video Course Library -

Calculate expected full-load current given HP, voltage, and efficiency. Course 4: Motor Starters & Contactors Focus: Manual and magnetic starters, contactor operation, overload relays.

A 50 HP motor trips on overload – megger reading is 2 MΩ at 1000V. Repair or replace? Course 10: Industrial Control Panel Design & NFPA 79 Focus: Panel layout, wire bending space, grounding, and electrical standards.

| Segment | Topic | Key Demo | |---------|-------|-----------| | 1 | Digital multimeter (DMM) basics: V, A, Ω, continuity | Measure line voltage (120V/480V) | | 2 | Clamp meter – measuring current without breaking circuit | Measure motor FLA in a panel | | 3 | Insulation resistance tester (megohmmeter) | Test motor winding insulation | | 4 | Non-contact voltage tester & solenoid tester | Verify absence of voltage | | 5 | Understanding test lead categories (CAT III / CAT IV) | Compare meters for industrial use | 10 Industrial Electrical Training Video Course Library

Focus: NFPA 70E, arc flash, lockout/tagout (LOTO), and hazard recognition.

Diagnose a blown fuse using continuity and voltage measurements. Course 3: AC/DC Motor Theory & Nameplate Interpretation Focus: Induction motors, DC motors, nameplate data, and basic motor physics. Calculate expected full-load current given HP, voltage, and

Using a schematic, find why a pump will not start – all indicators are off. Course 9: Electric Motor Maintenance & Failure Analysis Focus: Megger testing, bearing replacement, alignment, and winding evaluation.

| Segment | Topic | Key Demo | |---------|-------|-----------| | 1 | Contactors – coil, contacts, arc chutes, enclosure types | Open a NEMA contactor | | 2 | Manual motor starters – toggle & pushbutton | Wire a simple start/stop circuit | | 3 | Magnetic motor starter – 3-pole contactor + overload relay | Assemble a starter on a DIN rail | | 4 | Overload relays – thermal (bimetallic) vs. electronic | Trip test with a heat gun | | 5 | Selecting starter size based on motor HP & voltage | Sizing exercise for a 25 HP motor | Repair or replace

| Segment | Topic | Key Demo | |---------|-------|-----------| | 1 | Fuse construction: fast-blow, time-delay, Class CC, J, RK5, T | Cutaway of a Class J fuse | | 2 | Circuit breaker thermal-magnetic trip mechanism | Demonstrate instantaneous vs. long-time trip | | 3 | Understanding trip curves (B, C, D, K) | Overlay trip curves on a single chart | | 4 | Selective coordination – why it matters | Two breakers in series test | | 5 | SCCR (Short-Circuit Current Rating) & fuse replacement safety | Damage from wrong fuse type |